Knock Sensor: Installation

Install the knock sensor to the cylinder block.
NOTE:
- The extraction area of the knock sensor cord must be positioned at a 60 x angle relative to the engine rear.
- For tightening torque, < Ref. to COMPONENTS , General Description. >
  
  Fig 1: Installing Knock Sensor To Cylinder Block
  Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Connecting Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air cleaner case.
< Ref. to INSTALLATION , Air Cleaner Case. >
Connect the battery ground cable to battery.

Fig 3: Connecting Battery Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.