Check Interrupt Relay Circuit

CHECKING STEPS REFERENCE

Step	Check	Yes	No
1 CHECK INTERRUPT RELAY. Remove and check the interrupt relay. < Ref. to INTERRUPT RELAY . >	Is the interrupt relay OK?	Go to step 2.	Replace the interrupt relay.
2 CHECK POWER SUPPLY FOR INTERRUPT RELAY. Measure the voltage between the interrupt relay harness connector terminal and chassis ground. Connector & terminal Without On Star: (B59) No. 1 (+) - Chassis ground (-): With On Star: (B59) No. 4 (+) - Chassis ground (-):	Is the measured value more than 10 V when ignition switch is turned to START?	Go to step 3.	Check the harness for open circuits and shorts between the interrupt relay and ignition switch.
3 CHECK HARNESS BETWEEN INTERRUPT RELAY AND SECURITY CONTROL MODULE. Turn the ignition switch to OFF. Disconnect the security control module harness connector. Measure the resistance between the interrupt relay harness connector terminal and security control module harness connector terminal. Connector & terminal Without On Star: (B59) No. 4 - (B93) No. 15: With On Star: (B59) No. 2 - (B93) No. 15:	Is the measured value less than 10Ω?	Replace the security control module.	Check the harness for open circuits and shorts between the interrupt relay and security control module.