LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Security And Locks >> Keyless Entry System >> Inspection >> Check Output Signal To Integrated Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Output Signal To Integrated Module

OUTPUT SIGNAL TO INTEGRATED MODULE

Step Check Yes No
1 CHECK OUTPUT SIGNAL. 
Measure the voltage between the keyless entry control module harness connector terminal and chassis ground when UNLOCK/DISARM button of transmitter is pressed.
Connector & terminal 
(B176) No. 2 (+) - Chassis ground (-): 		 Is the measured value less than 1.5 V? Go to step 2.  Replace the keyless entry control module.
2 CHECK OUTPUT SIGNAL. 
Measure the voltage between the keyless entry control module harness connector terminal and chassis ground when LOCK/ARM button of transmitter is pressed.
Connector & terminal 
(B176) No. 1 (+) - Chassis ground (-): 		 Is the measured value less than 1.5 V? Go to step 3.  Replace the keyless entry control module.
3 CHECK HARNESS BETWEEN KEYLESS ENTRY CONTROL MODULE AND INTEGRATED MODULE. 
  1. Disconnect the keyless entry control module harness connector and integrated module harness connector.
  2. Measure the resistance between the keyless entry control module harness connector terminal and integrated module harness connector terminal.

Connector & terminal 
(B176) No. 2 - (B280) No. 14: 
(B176) No. 1 - (B280) No. 13: 		 Is the measured value less than 10 Ω? Replace the integrated module. Check the harness for open circuit or shorts between the keyless entry control module and integrated module.
scientia non olet · About LEMON Manuals