LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation/Driver Info >> Combination Meter System >> Inspection >> Check Outside Temperature Indicator
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Outside Temperature Indicator

OUTSIDE TEMPERATURE INDICATOR

Step Check Yes No
1 CHECK POWER SUPPLY FOR AMBIENT SENSOR. 
  1. Turn ignition switch OFF.
  2. Disconnect connector from ambient sensor.
  3. Turn ignition switch ON.
  4. Measure voltage between ambient sensor harness connector terminal and chassis ground.

Connector & terminal 
(F78) No. 1 (+) - Chassis ground (-): 		 Is the measured value more than 4 V? Go to step 2.  Check harness for open or short between ambient sensor and combination meter.
2 CHECK AMBIENT SENSOR. 
  1. Turn ignition switch OFF.
  2. Remove ambient sensor.
  3. Check ambient sensor. < Ref. to , INSPECTION , Ambient Sensor. >
 Is the ambient sensor OK? Go to step 3.  Replace the ambient sensor.
3 CHECK HARNESS BETWEEN AMBIENT SENSOR AND COMBINATION METER. 
  1. Disconnect connector from combination meter.
  2. Measure resistance between ambient sensor harness connector terminal and combination meter harness connector terminal.

Connector & terminal 
(F78) No. 2 - (i10) No. 22: 		 Is the measured value less than 10 ohm? Go to step 4.  Repair wiring harness.
4 CHECK OUTSIDE TEMPERATURE INDICATOR. 
  1. Connect combination meter harness connector.
  2. Connect a resistor (1.7 kohm) between terminals of ambient sensor harness connector.
  3. Turn ignition switch ON and check the outside temperature indicator display.
 Is the outside temperature indicator indicating 25°C (77°F)? Outside temperature indicator is OK. Replace combination meter printed circuit.
scientia non olet · About LEMON Manuals