LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2005 >> Baja Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H4SO) >> Clear Memory Mode >> Operation >> SUBARU Select Monitor (Normal Mode)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

SUBARU Select Monitor (Normal Mode)

  1. On the << Main Menu >> display screen, select the {2. Each System Check} and press the [YES] key.
  2. On the << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after displayed the information of engine type.
  4. On the << Engine Diagnosis >> display screen, select the {Clear Memory} and press the [YES] key.
  5. When the 'Done' and 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
    NOTE:
    • After the memory has been cleared, the ISC must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine. (AT vehicles only)
    • For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
scientia non olet · About LEMON Manuals