Section 10 (Clutch System): General Description: Specifications
WARNING: This page is about a different variant/trim than selected.
GENERAL SPECIFICATIONS
| Model | NON-TURBO | TURBO | |||||||
|---|---|---|---|---|---|---|---|---|---|
| Clutch cover | Type | Push type | Pull type | ||||||
| Diaphragm set load | kgf (lb) | 580 (1276) | 800 (1764) | ||||||
| Clutch disc | Facing material | Woven (Non asbestos) | |||||||
| O.D. x I.D. x thickness | mm (in) | Flywheel side | 225 x 150 x 3.5 (8.86 x 5.91 x 0.138) | 230 x 155 x 3.2 (9.06 x 6.10 x 0.126) | |||||
| Pressure plate side | 230 x 155 x 3.5 (9.06 x 6.10 x 0.138) | ||||||||
| Spline O.D. | mm (in) | 25.2 (0.992), (No. of teeth: 24) | |||||||
| Clutch release lever ratio | 1.6 | 1.7 | |||||||
| Release bearing | Grease-packed self-aligning | ||||||||
| Clutch pedal | Full stroke | mm (in) | 130-135 (5.12-5.31) | ||||||
| Free play | mm (in) | 4-12 (0.15-0.48) | |||||||
| Clutch disc | Depth of rivet head | Standard | Flywheel side: 1.35-1.95 (0.053-0.077) Clutch cover side: 1.65-2.25 (0.065-0.089) |
||||||
| Limit of sinking | 0.3 (0.012) | ||||||||
| Limit for deflection | mm (in) | 0.7 (0.028) at R = 107.5 (4.23) | 0.7 (0.028) at R = 110 (4.33) | ||||||
|
|||||||||