General Diagnostic Table: Inspection
DIAGNOSTIC CHART
| Symptom | Possible cause | Remedy |
|---|---|---|
| 1. Select lever | Starter does not run. | Adjust select cable and inhibitor switch, or inspect circuit. |
| Back-up light does not light up. | Adjust select cable and inhibitor switch, or inspect circuit. | |
| AT shift lock system does not operate normally. | Adjust select cable and inhibitor switch, or inspect circuit. | |
| 2. MT gear shift lever (6MT) | Shift into reverse is impossible. | Adjust reverse check cable. |
| Shift into reverse is possible without pulling up slider. | Adjust or replace reverse check cable. | |
| Slider cannot be pulled up. Or slider is pulled up being sticked. |
|