Knock Sensor: Installation

WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

Install knock sensor to cylinder block.
Tightening torque:

24 N.m (2.4 kgf-m, 17.4 ft-lb)

NOTE: The extraction area of the knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Fig 1: Installing Knock Sensor To Cylinder Block
Courtesy of SUBARU OF AMERICA, INC.
Connect knock sensor connector.

Fig 2: Connecting Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install knock sensor harness connector to connector bracket.
Install air cleaner case.
< Ref. to INSTALLATION , Air Cleaner Case. >
Connect battery ground cable.

Fig 3: Connecting Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.