Accelerator Control Cable: Installation
WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
- Install in the reverse order of removal.
- Apply grease to the point (accelerator cable end on engine side) shown in the figure below.
Part No. 004404002 (Slico lube G-30M)
CAUTION:- If cable clamp is damaged, replace it with a new one.
- Never fail to cover outer cable end with boot.
- Be careful not to kink accelerator cable.
- Do not apply grease except for special area.
- Adjustment after pedal installation < Ref. to , INSTALLATION , Accelerator Pedal. >