General Scan Tool
- After performing the diagnostics and clearing the memory, check for any remaining unresolved trouble data. < Refer to CLEAR MEMORY MODE . >
- Idle the engine.
- Connect the test mode connector (A) located under the glove box.
- Connect the Subaru Select Monitor to the data link connector at the lower portion of instrument panel (on the driver's side).CAUTION: Do not connect any scan tools except Subaru Select Monitor or general scan tool.
- Start the engine.NOTE: Make sure the select lever is placed in "P" position before starting.
- Using the select lever, turn the "P" position switch and the "N" position switch to ON.
- Depress the brake pedal to turn brake switch ON.
- Keep the engine speed in 2,500 - 3,000 rpm range for 40 seconds.
- Shift the select lever in the "D" range and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).NOTE:
- For AWD model, release the parking brake.
- The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. When engine control diagnosis is finished, perform the ABS memory clearance procedure of self-diagnosis system.
- Using the general scan tool, check DTC and record the result(s).
NOTE:
- For detailed operation procedure, refer to the general scan tool operation manual.
- For details concerning DTC, refer to "LIST OF DIAGNOSTIC TROUBLE CODE (DTC) ".