Transmission Control Device: Installation

Install the detention spring to transmission case.
Tightening torque: 6 N.m (0.6 kgf-m, 4.3 ft-lb)

Fig 1: Identifying Detent Spring
Courtesy of SUBARU OF AMERICA, INC.
Insert the range select lever, and tighten the bolt.
Tightening torque: 6 N.m (0.6 kgf-m, 4.3 ft-lb)

Fig 2: Identifying Range Select Lever And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Insert the manual plate and parking rod.

Fig 3: Identifying Range Select Lever, Manual Plate And Parking Rod
Courtesy of SUBARU OF AMERICA, INC.
Insert the spring pin to manual plate.

Fig 4: Identifying Spring Pin To Manual Plate
Courtesy of SUBARU OF AMERICA, INC.
Install the control valve assembly and oil pan. < Ref. to INSTALLATION . >
Turn over the transmission case to its original position.
Install the pitching stopper bracket.
Tightening torque: 41 N.m (4.2 kgf-m, 30.4 ft-lb)
Install the inhibitor switch and adjust the inhibitor switch. < Ref. to INHIBITOR SWITCH . >
Insert the inhibitor switch and transmission connector into stay.

Fig 5: Identifying Inhibitor Switch Harness And Transmission Harness
Courtesy of SUBARU OF AMERICA, INC.
Install the air breather hose. < Ref. to INSTALLATION . >
Insert the input shaft while turning it lightly by hand and verify the protrusion amount.
Normal protrusion A: 50 - 55 mm (1.97-2.17 in)

Fig 6: Identifying Torque Converter Input Shaft Dimension
Courtesy of SUBARU OF AMERICA, INC.
Install the torque converter clutch assembly. < Ref. to INSTALLATION . >
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION . >