LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2006 >> Outback R >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (A/T & M/T Control Systems) >> Select Cable >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Select Cable: Removal

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Prior to removal, set the lever to "N" position.
  4. Lift-up the vehicle.
  5. Remove the front and center exhaust pipe. (Non-TURBO model) < Ref. to REMOVAL , FRONT EXHAUST PIPE. >
  6. Remove center exhaust pipe. (TURBO model) < Ref. to REMOVAL , CENTER EXHAUST PIPE. >
  7. Remove the heat shield cover. (If equipped)
  8. Remove the snap pin from range select lever.
    Fig 1: Identifying Select Cable Components
    G04990168Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the plate assembly from transmission case.
    Fig 2: Identifying Plate Assembly From Transmission Case
    G04990169Courtesy of SUBARU OF AMERICA, INC.
  10. Disconnect the cable from select lever, and then remove the cable bracket.
    Fig 3: Identifying Adjusting Nuts And Cable Bracket
    G04990170Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the select cable from plate assembly.
scientia non olet · About LEMON Manuals