Section 12 (Cooling System (H4SO)): Radiator: Installation

WARNING: This page is about a different variant/trim than selected.

Attach the radiator lower cushion to the hole on the radiator lower bracket.

Fig 1: Identifying Radiator Lower Bracket
Install the radiator to vehicle.
NOTE: Make pins on the lower side of radiator be fitted into the radiator lower cushions on body side.
Install the radiator upper brackets and tighten the bolts.
Tightening torque: 12 N.m (1.2 kgf-m, 8.9 ft-lb)

Fig 2: Locating Radiator Upper Brackets
Connect the radiator inlet hose.

Fig 3: Connecting Radiator Inlet Hose
Install the air intake duct. < Ref. to INSTALLATION , Air Intake Duct. >
Install the hood stay holder.

Fig 4: Locating Hood Stay Holder Bolt
Install the reservoir tank. < Ref. to INSTALLATION , Reservoir Tank. >
Connect the over flow hose.
Lift-up the vehicle.
Connect the ATF cooler hoses. (AT model)

Fig 5: Connecting ATF Cooler Hoses
Connect the radiator outlet hose.

Fig 6: Locating Radiator Outlet Hose
Connect the radiator main fan motor connector (A) and sub fan motor connector (B).

Fig 7: Connecting Radiator Main Fan Motor Connector

Fig 8: Connecting Sub Fan Motor Connector
Install the radiator under cover.
Install the under cover.
Lower the vehicle.
Connect the battery ground cable to the battery.

Fig 9: Connecting Battery Ground Cable To Battery
Fill engine coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
Check the ATF level. < Ref. to INSPECTION , Automatic Transmission Fluid. >