LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2006 >> Outback XT, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Security And Locks) >> Keyless Transmitter >> Replacement >> Transmitter Registration Using SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmitter Registration Using SUBARU Select Monitor

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • A maximum of 4 transmitters can be registered with a vehicle.
  • When the transmitter is replaced or added, it is necessary to register a new transmitter.
  1. Connect the SUBARU Select Monitor to the vehicle.
  2. Turn the ignition switch ON.
  3. Select {2. CHECK INDIVIDUAL SYSTEM} → {7. KEYLESS UNIT MODE} → {8. KEYLESS ID REGISTRATION} from the «MAIN MENU», and then press the [YES] key.
  4. Enter the ID number with eight digits that is printed on the vinyl package that stored the transmitter or the transmitter internal circuit from the last digit. And then, press the [YES] key.
    NOTE: The number increases by pressing the up arrow key of SUBARU Select Monitor, decreases by pressing the down arrow key, moves to the left by pressing the [<] key, and moves to the right by pressing the [>] key.
  5. The entered ID number is displayed. Make sure that the number is the same as the number printed on the vinyl package.
  6. If these numbers match, press the [YES] key. If NG, press the [NO] key and return to step  3) to enter the ID number again.
  7. «ID REGISTERING...» is displayed and the registration starts.
  8. If the «ID REGISTRATION IS COMPLETED» is displayed, the registration of the transmitter is completed.
  9. End the registration: Select «END: NO», and then press the [NO] key to return to {8. KEYLESS ID REGISTRATION}. Add the successive transmitters as necessary: Select «NEXT: YES», and then press the [YES] key to return to 3).
    NOTE:
    • When the registration has failed, «CANNOT ID REGISTRATION. TRY AGAIN.» is displayed. At this time, the system returns to {8. KEYLESS ID REGISTRATION} by pressing the [YES] key. Try the procedures again from step  2).
    • When the 4th transmitter registration has been completed, «END: NO» is displayed on the SUBARU Select Monitor screen. At this time, the system returns to {8. KEYLESS ID REGISTRATION} by pressing the [NO] key.
scientia non olet · About LEMON Manuals