LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2006 >> Outback XT, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Security And Locks) >> Security System >> Inspection >> Check Interrupt Relay Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Interrupt Relay Circuit

WARNING: This page is about a different car, the 2006 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
INTERRUPT RELAY REFERENCE

Step Check Yes No
1 CHECK INTERRUPT RELAY. 
Remove and check the interrupt relay. < Ref. to INTERRUPT RELAY . >		 Is the interrupt relay OK? Go to step 2.  Replace the interrupt relay.
2 CHECK POWER SUPPLY FOR INTERRUPT RELAY. 
Measure the voltage between the interrupt relay harness connector terminal and chassis ground.
Connector & terminal 
(B59) No. 4 (+) - Chassis ground (-): 		 Is the measured value more than 10 V when ignition switch is turned to START? Go to step 3.  Check the harness for open circuits and shorts between the interrupt relay and ignition switch.
3 CHECK HARNESS BETWEEN INTERRUPT RELAY AND KEYLESS ENTRY CONTROL MODULE. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the keyless entry control module harness connector.
  3. Measure the resistance between the interrupt relay harness connector terminal and keyless entry control module harness connector terminal.

    Connector & terminal 

    (B59) No. 2 - (B176) No. 12: 

 Is the measured value less than 10 Ω? Replace the keyless entry control module. Check the harness for open circuits and shorts between the interrupt relay and keyless entry control module.
scientia non olet · About LEMON Manuals