Converter Case: Installation

Check the appearance of each component and clean them.
Press-fit the oil seal to converter case using ST.
ST 398437700 DRIFT

Fig 1: Identifying Converter Case With ST
Courtesy of SUBARU OF AMERICA, INC.
Install the differential assembly to the case. < Ref. to INSTALLATION , Front Differential Assembly. >
Install the right and left side retainers. < Ref. to ADJUSTMENT , Front Differential Assembly. >
Install new seal pipe to converter case.

Fig 2: Identifying Seal Pipe
Courtesy of SUBARU OF AMERICA, INC.
Install the rubber seal to converter case.

Fig 3: Identifying Rubber Seal
Courtesy of SUBARU OF AMERICA, INC.
Apply proper amount of liquid gasket to the entire matching surface of converter case.
Liquid gasket:

THREE BOND 1215 (Part No. 004403007)

Fig 4: Applying Amount Of Liquid Gasket To Entire Matching Surface Of Converter Case
Courtesy of SUBARU OF AMERICA, INC.
Install the converter case without damaging bushing and oil seal.
Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)

Fig 5: Identifying Converter Case
Courtesy of SUBARU OF AMERICA, INC.
Insert the inhibitor switch and transmission connector to the stay.
Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
Install the oil cooler pipe. < Ref. to INSTALLATION , ATF Cooler Pipe and Hose. >
Install the oil charge pipe with O-ring. < Ref. to INSTALLATION , Oil Charge Pipe. >
Insert the input shaft while rotating it lightly by hand, and then check the amount of protrusion.
Normal protrusion A:

50 - 55 mm (1.97 - 2.17 in)

Fig 6: Identifying Input Shaft
Courtesy of SUBARU OF AMERICA, INC.
Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >