LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> B9 Tribeca Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls (Diagnostics) (H6DO) >> Subaru Select Monitor >> Operation >> Led Operation Mode For Engine
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Led Operation Mode For Engine

  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Engine Control System}.
  3. Select the [OK] after the information of engine type has been displayed.
  4. On the «Engine Diagnosis» display screen, select the {Current Data Display/Save}.
  5. On the «Data Display» screen, select the {Data LED Display}.
  6. Using the scroll key, scroll the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
      SUPPORT DATA

      Description Display Message When LED "ON" required
      Test mode signal Test mode terminal D check/U check D check
      Neutral position switch signal Neutral SW Neutral/Other than neutral Neutral
      Idle switch signal Soft idle SW Idle/Other than idle In idle
      Ignition switch signal Ignition SW ON Input/OFF Input ON input
      Power steering switch signal Power steering SW ON Input/OFF Input ON input
      Air conditioning switch signal A/C SW ON Input/OFF Input ON input
      Starter switch signal Starter SW ON Input/OFF Input ON input
      Front oxygen monitor 1 FtO2 monitor 1 Lean/Rich Rich
      Front oxygen monitor 2 FtO2 monitor 2 Lean/Rich Rich
      Knocking signal Knock signal Yes/No Yes
      Crankshaft position sensor signal Crankshaft angle signal Yes/No Yes
      Camshaft position sensor signal Camshaft angle signal Yes/No Yes
      Rear defogger switch signal Rear defogger SW ON Input/OFF Input ON input
      Blower fan switch signal Blower fan SW ON Input/OFF Input ON input
      Light switch signal Light SW ON Input/OFF Input ON input
      Wiper switch signal Wiper SW ON Input/OFF Input ON input
      A/C middle pressure switch signal A/C middle pressure SW ON Input/OFF Input ON input
      Air conditioner compressor relay signal Compressor relay ON output/OFF output ON output
      Drain valve signal Vent. Solenoid Valve ON or OFF When drain valve is ON.
      AT retard angle demand signal AT retard angle demand Yes/No Yes
      AT fuel cut signal AT fuel cut Yes/No Yes
      VDC torque down prohibition output Torque down output ON/OFF Prohibition
      VDC torque down demand Torque down demand Yes/No Yes
      AT coordinate permission signal AT coordinate permission signal ON/OFF Permission
      Electronic throttle control motor relay signal ETC motor relay ON/OFF ON
      Stop light switch signal Stop SW ON Input/OFF Input ON input
      SET/COAST switch signal SET/CST SW ON Input/OFF Input ON input
      RESUME/ACCEL switch signal RES/ACC SW ON Input/OFF Input ON input
      Brake switch signal Brake SW ON Input/OFF Input ON input
      Main switch signal Main SW ON Input/OFF Input ON input
      Body integrated unit data reception Body Int. Unit Data Yes/No Yes
      Body integrated unit counter update Body Int. Unit Count Yes/No Yes
      Cruise control cancel switch signal CC Cancel SW ON Input/OFF Input ON input
      Variable valve lift diagnosis oil pressure switch signal 1 Oil Temperature SW1 ON/OFF ON
      Variable valve lift diagnosis oil pressure switch signal 2 Oil Temperature SW2 ON/OFF ON
NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL ".