Drive Cycle H
- Perform the Clear Memory Mode. <Ref. to CLEAR MEMORY MODE . >
- Read the engine coolant temperature, intake air temperature and fuel temperature with ignition switch ON. <Ref. to READ CURRENT DATA FOR ENGINE (NORMAL MODE) , Operation, Subaru Select Monitor. >
- Start the engine if the value in step 2) meets the following two conditions.
Condition:
|engine coolant temperature - intake air temperature | ≤ 5°C (41 °F)
|engine coolant temperature - fuel temperature| ≤ 2°C (36°F)
NOTE:- If the value does not meet the conditions, turn the ignition switch to OFF and wait until it meets.
- Start the engine in P range (AT model) or in N position (MT model).
- Idle the engine for one minute in the condition of step 3.
DTC CHART
| DTC | Item | Condition |
|---|---|---|
| *P1602 | Control Module Programming Error | - |