ABS Control Module and Hydraulic Control Unit (ABSCM&H/U): Installation

Install the ABSCM&H/U bracket.
Tightening torque:

33 N.m (3.4 kgf-m, 24.6 ft-lb)
Install the ABSCM&H/U by aligning the damper groove of the ABSCM&H/U to the bracket side claw.
NOTE: Check the identification marks of the ABSCM&H/U.

Tightening torque:

7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Fig 1: Identifying ABSCM&H/U Nuts
Courtesy of SUBARU OF AMERICA, INC.
Connect the brake pipes to their correct positions on the ABSCM&H/U.
Tightening torque:

15 N.m (1.5 kgf-m, 10.8 ft-lb)
Using cable clip, secure the ABSCM&H/U harness to the bracket.
Connect the connector to the ABSCU & H/U.
NOTE:
- Be sure to remove all foreign matter from inside the connector before connecting.
- Make sure that the ABSCM&H/U connector is securely locked.
Connect the grounding wire of the ABSCM&H/U and apply rust-prevention wax.
Install the air cleaner case. <Ref. to INSTALLATION , Air Cleaner Case. >
Bleed air from the brake system.