Fuel Pump: Removal

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION: Be careful not to spill fuel.

NOTE: Fuel pump assembly consists of fuel pump, fuel filter and fuel level sensor.

Set the vehicle on a lift.
Release the fuel pressure. <Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, FUEL .>
Disconnect the ground cable from the battery.

Fig 1: Connecting Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.
Open the fuel filler flap lid, and remove the fuel filler cap.
Lift up the vehicle.
Drain fuel from fuel tank. <Ref. to DRAINING FUEL , PROCEDURE, FUEL .>
Remove the trunk room mat. (Sedan model)
Remove the luggage floor mat. (Wagon model) <Ref. to REMOVAL , Luggage Floor Mat .>
Remove the service hole cover.

Fig 2: Identifying Service Hole Cover
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from fuel pump.

Fig 3: Locating Fuel Pump Connector
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the quick connector and then disconnect the fuel delivery hose. <Ref. to REMOVAL , Fuel Delivery And Evaporation Lines .>
Move the clips, and disconnect the jet pump hose (A).

Fig 4: Identifying Jet Pump Hose
Courtesy of SUBARU OF AMERICA, INC.
Remove the nuts which install fuel pump assembly onto fuel tank.

Fig 5: Identifying Fuel Pump Assembly Nuts
Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel pump assembly from the fuel tank.

NOTE: When removing, be careful not to let the float portion of the fuel level sensor interfere with fuel tank.