SUBARU Select Monitor (OBD Mode)

On the «Main Menu» display screen, select {Each System Check}.
On the «System Selection Menu» display screen, select {Engine Control System}.
Select the [OK] after the information of engine type has been displayed.
On the «Engine Diagnosis» display screen, select the {OBD System}.
On the «OBD Menu» display screen, select {DTC Clear}.
When the "Clear Diagnostic Code?" is shown on the screen, select the [OK].
Turn the ignition switch to OFF and then close the Subaru Select Monitor.
NOTE:
- Initial diagnosis of electronic throttle control is performed after memory clearance. Therefore, start the engine 10 seconds or more after have turning the ignition switch to ON.
- For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".