Read Current Data For Engine (OBD Mode)

On the «Main Menu» display screen, select {Each System Check}.
On the «System Selection Menu» display screen, select {Engine Control System}.
Select the [OK] after the information of engine type has been displayed.
On the «Engine Diagnosis» display screen, select the {OBD System}.
On the «OBD Menu» display screen, select the {Current Data Display/Save}.
On the «Data Display Menu» screen, select {Data Display}.
Using the scroll key, scroll the display screen up or down until the desired data is shown.

A list of the support data is shown in the following table.

SUPPORT DATA CHART

Contents	Display	Unit of measure	Note (at idling)
Number of diagnosis code	Number of Diag. Code:	-	-
Condition of malfunction indicator light	Ml (MIL)	-	ON or OFF
Monitoring test of misfire	Misfire Monitoring	-	Finish or incomplete
Monitoring test of fuel system	Fuel system monitoring	-	Finish or incomplete
Monitoring test of comprehensive component	Component monitoring	-	Finish or incomplete
Test of catalyst	Catalyst Diagnosis	-	Finish or incomplete
Test of heating-type catalyst	Heated catalyst	-	No support
Test of evaporative emission purge control system	Evaporative purge system	-	Finish or incomplete
Test of secondary air system	Secondary air system	-	Finish or incomplete
Test of air conditioning system refrigerant	A/C system refrigerant	-	No support
Test of oxygen sensor	Oxygen sensor	-	Finish or incomplete
Test of oxygen sensor heater	02 Heater Diagnosis	-	Finish or incomplete
Test of EGR system	EGR system	-	No support
Air fuel ratio control system for bank 1	Fuel System for Bank 1	-	Normal CLOSE
Engine load data	Calculated load value	%	1.6%
Engine coolant temperature signal	Coolant Temp.	°C or °F	+91°C or 196°F
Short term fuel trim by front oxygen (A/F) sensor	Short term fuel trim B1	%	+0.0 %
Long term fuel trim by front oxygen (A/F) sensor	Long term fuel trim B1	%	+1.6 %
Intake manifold absolute pressure signal	Mani. Absolute Pressure	mmHg, kPa, inHg or psig	256 mmHg
Engine speed signal	Engine Speed	rpm	693 rpm
Vehicle speed signal	Vehicle Speed	km/h or MPH	0km/h
#1 Cylinder ignition timing	Ignition timing adv. #1	°	+16.0°
Intake air temperature signal	Intake Air Temp.	°C or °F	54°C or 129°F
Amount of intake air	Mass Air Flow	g/s or lb/m	3.1 g/s
Throttle position signal	Throttle Opening Angle	%	13%
Oxygen sensor #12	Oxygen Sensor#12	V	+ 0.800 V
Air fuel ratio correction by rear oxygen sensor	Short term fuel trim #12	%	+0.8%
On-board diagnostic system	OBD System	-	CARB-OBD2
Oxygen sensor #11	Oxygen Sensor #11	-	Support
Rear oxygen sensor output signal	Oxygen Sensor #12	-	Support
A/F lambda signal	A/F sensor #11	-	0.984
A/F sensor output signal	A/F sensor #11	V	2.712 V
A/F lambda signal #11	A/F sensor #11	-	0.992
A/F sensor current #11	A/F sensor #11	mA	-0.03 mA
Secondary air control status	Secondary air system	-	-
Time elapsed after engine start	Elapsed Time After Starting Engine	sec	-
Elapsed time after MIL illuminating	Elapsed Time After MIL Illuminates	km or miles	-
Evaporative purge	Evaporative purge	%	-
Fuel level	Fuel level	%	-
Number of warm ups after DTC clear	Number Of Warm Ups After DTC Clear	-	-
Travel distance after DTC clear	Travel distance after DTC clear	km or miles	-
Fuel tank pressure	Fuel Tank Pressure	mmHg, kPa, inHg or psig	-
Atmospheric pressure	Atmospheric Pressure	mmHg, kPa, inHg or psig	-
Catalyst temperature #1	Catalyzer temperature #1	°C or °F	-
Misfire monitoring	Misfire Monitoring	Enable	YES or NO
Misfire monitoring	Misfire Monitoring	Comp	YES or NO
Fuel system diagnosis	Fuel system monitoring	Enable	YES or NO
Fuel system diagnosis	Fuel system monitoring	Comp	YES or NO
Component monitoring	Component monitoring	Enable	YES or NO
Component monitoring	Component monitoring	Comp	YES or NO
Catalyst diagnosis	Catalyst Diagnosis	Enable	YES or NO
Catalyst diagnosis	Catalyst Diagnosis	Comp	YES or NO
Heated catalyst diagnosis	Heated catalyst	Enable	N/A
Heated catalyst diagnosis	Heated catalyst	Comp	N/A
Evaporative purge system diagnosis	Evaporative purge system	Enable	YES or NO
Evaporative purge system diagnosis	Evaporative purge system	Comp	YES or NO
Secondary air system	Secondary air system	Enable	YES or NO
Secondary air system	Secondary air system	Comp	YES or NO
A/C system refrigerant diagnosis	A/C system refrigerant	Enable	N/A
A/C system refrigerant diagnosis	A/C system refrigerant	Comp	N/A
Oxygen sensor diagnosis	Oxygen sensor	Enable	YES or NO
Oxygen sensor diagnosis	Oxygen sensor	Comp	YES or NO
Oxygen heater diagnosis	02 Heater Diagnosis	Enable	YES or NO
Oxygen heater diagnosis	02 Heater Diagnosis	Comp	YES or NO
EGR diagnosis	EGR system	Enable	N/A
EGR diagnosis	EGR system	Comp	N/A
ECM power voltage	ECM power voltage	V	-
Absolute load	Absolute load	%	-
A/F target lambda	A/F target lambda	-	-
Relative throttle opening angle	Relative throttle position	%	-
Ambient temperature	Ambient temperature	°C or °F	-
Absolute throttle opening angle 2	Absolute throttle opening angle 2	%	-
Absolute accelerator opening angle 1	Absolute accelerator opening angle 1	%	-
Absolute accelerator opening angle 2	Absolute accelerator opening angle 2	%	-
Target throttle opening angle	Target throttle opening angle	%	-
Engine operation time during MIL on	Engine operating time during MIL illuminates	min	-
Elapsed time after DTC clear	Elapsed time after DTC clear	min	-
Fuel used	Fuel used	-	-
Relative accelerator opening angle	Relative accelerator opening angle	%	-

NOTE: For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".