LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2007 >> Outback XT Limited, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System (Abs) >> ABS Sequence Control >> Operation >> Abs Sequence Control With SUBARU Select Monitor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Abs Sequence Control With SUBARU Select Monitor

NOTE: In the event of any trouble, the ABS sequence control will not operate.
  1. Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Set the Subaru Select Monitor switch to ON.
  4. Set the Subaru Select Monitor to "Brake Control" mode.
  5. When the "Function check sequence" is selected, the "ABS sequence control" will start.
  6. Execute the following operations when the message "Press the brake pedal so that the brake pedal force is between 100 and 150 kgf" is displayed.
    1. When the brake tester is used, press brake pedal pad with a force of 1,000 N (102 kgf, 225 lb).
    2. When using a pressure gauge, depress the brake pedal so that the pressure gauge indicates 3,500 kPa (36 kg/cm2 , 511 psi).
  7. "Press the "YES" key" will be displayed. Press the [YES] key.
  8. The brake system being operated is displayed on the Subaru Select Monitor.
scientia non olet · About LEMON Manuals