Fuel Sub Level Sensor: Removal

WARNING: This page is about a different variant/trim than selected.

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION:

Be careful not to spill fuel.
Prior to start work, be sure to set the fuel volume to three-forth full of the fuel tank. If the fuel is more than three-forth full of the fuel tank, be careful because the fuel may spill out.

Drain fuel. <Ref. to DRAINING FUEL , PROCEDURE, Fuel .>
Remove the rear seat.
Remove the service hole cover.
1. Remove bolt (A).
2. Push the grommet (B) down and remove the service hole cover.
  
  Fig 1: Identifying Service Hole Cover, Grommet And Bolts
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from the fuel sub level sensor.

Fig 2: Identifying Fuel Sub Level Sensor And Connector
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the quick connector, then disconnect the fuel delivery hose, return hose and jet pump hose. <Ref. to REMOVAL , Fuel Delivery, Return and Evaporation Lines .>
Remove the nuts and bolts which install fuel sub level sensor on fuel tank.

Fig 3: Identifying Delivery Hose, Return Hose And Jet Pump Hose
Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel sub level sensor.