ABS Control Module and Hydraulic Control Unit (ABSCM&H/U): Installation

Install the ABSCM&H/U bracket.
Tightening torque:

33 N.m (3.3 kgf-m, 24 ft-lb)
Install the ABSCM&H/U by aligning the damper groove of the ABSCM&H/U to the bracket side claw.
NOTE: Check the identification marks of the ABSCM&H/U.

Tightening torque:

7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Fig 1: Locating ABSCM&H/U Nuts
Courtesy of SUBARU OF AMERICA, INC.
Connect the brake pipes to their correct ABSCM&H/U positions.
Tightening torque:

15 N.m (1.5 kgf-m, 10.8 ft-lb)
Using a harness clip, secure the ABSCM&H/U harness to the bracket.
Connect the connector to the ABSCM&H/U.
NOTE:
- Be sure to remove all foreign matter from inside the connector before connecting.
- Make sure the ABSCU&H/U connector is securely locked.
Bleed air from the brake system.