VDC Control Module (VDCCM): Installation

Install in the reverse order of removal.

Tightening torque:

Refer to "COMPONENT" of "General Description". < Ref. to VDC CONTROL MODULE (VDCCM) , Component, General Description .>

CAUTION: After installation, always make the following two settings.

SRS roll connector and steering angle sensor centering setting
Yaw rate & lateral G sensor 0 point setting These two procedures are required to make the VDCCM recognize what position the vehicle is in later. Refer to Adjustments for the procedures for above settings. < Ref. to ADJUSTMENT , VDC Control Module (VDCCM).>