Injector Control (Injection Quantity Control)
CAUTION:
After carrying out the Operation Check Mode, perform the Clear Memory Mode < Ref. to
OPERATION , Clear Memory Mode> and Inspection Mode < Ref. to
PROCEDURE , Inspection Mode >.
- On the « System operation check mode » display, select the {Injector Control}.
- On the « Injector Control » display screen, select the {Injection Quantity Control}.
- On the « Start the Engine » display screen, start the engine and click the [OK] button.
- In the « Injection Quantity Control » screen, click the [
] button or the [
] button to change the setting values, then click the [OK] button.
Setting is possible in a range between 0 - 20%, in increments of 1%.
- Click the [Cancel] button to end the injection quantity control. The screen will return to the « Injector Control » screen.NOTE: For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".