Operating Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Apply grease (KOPR-KOTE: Part No. 003603001) to the contact point of the release lever and the operating cylinder.
Install in the reverse order of removal.
Tightening torque:

T1: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

T2: 37 N.m (3.8 kgf-m, 27.5 ft-lb)

Fig 1: Identifying Operating Cylinder Bolts
Courtesy of SUBARU OF AMERICA, INC.
NOTE:
- Be sure to install the clutch hose with the mark side facing upward.
- Be careful not to twist the clutch hose during installation.
  
  Fig 2: Identifying Clutch Hose And Operating Cylinder
  Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the operating cylinder, ensure that the clutch operates properly.
<Ref. to CLUTCH FLUID AIR BLEEDING . >