Select Cable: Installation

1. Install the select cable to plate assembly.

   Tightening torque: 

   18 N.m (1.8 kgf-m, 13.3 ft-lb) 

   Fig 1: Identifying Select Cable Bolt Tightening Torque

   Courtesy of SUBARU OF AMERICA, INC.
2. Install the select cable to range select lever.
3. Install the plate assembly to transmission.

   Tightening torque: 

   T: 25 N.m (2.5 kgf-m, 18.4 ft-lb) 

   Fig 2: Identifying Select Cable And Plate Assembly Bolts Tightening Torque

   Courtesy of SUBARU OF AMERICA, INC.
4. Install the washer and snap pin to range select lever.
   Fig 3: Identifying Washer, Snap Pin And Range Select Lever

   Courtesy of SUBARU OF AMERICA, INC.
5. Install new clamp paying attention to the installing direction.
   Fig 4: Identifying Clamp Installing Direction

   Courtesy of SUBARU OF AMERICA, INC.
6. Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.
   Fig 5: Fixing Cable To Bracket

   Courtesy of SUBARU OF AMERICA, INC.
7. Shift the select lever to the "N" range, and then adjust the select cable position. <Ref. to ADJUSTMENT , Select Cable. >
8. Install the heat shield cover.
   Fig 6: Identifying Heat Shield Cover

   Courtesy of SUBARU OF AMERICA, INC.
9. Install the front, center and rear exhaust pipes, and the muffler. (Non-turbo model)

   <Ref. to INSTALLATION , Front Exhaust Pipe for H4SO engine. > <Ref. to INSTALLATION , Rear Exhaust Pipe for H4SO engine. > <Ref. to INSTALLATION , Muffler for H4SO engine. >

10. Install the center, rear exhaust pipes and the muffler. (Turbo model)

<Ref. to INSTALLATION , Center Exhaust Pipe for H4DOTC engine. > <Ref. to INSTALLATION , Rear Exhaust Pipe for H4DOTC engine. > <Ref. to INSTALLATION , Muffler for H4DOTC engine. >