LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Security And Locks) >> Security System >> Inspection >> Check Security Indicator Light Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Security Indicator Light Circuit

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
SECURITY INDICATOR LIGHT CIRCUIT CHECKING PROCEDURE CHART

Step Check Yes No
1 CHECK SECURITY INDICATOR LIGHT. 
  1. Turn the ignition switch to OFF.
  2. Disconnect the harness connector of body integrated unit.
  3. Connect the resistor (100 Ω) between the body integrated unit harness connector terminal (i84) No. 33 and chassis ground.

    Connector & terminal 

    (i84) No. 33 - Chassis ground: 

 Does the security indicator light illuminate? Check the body integrated unit. < Ref. to BASIC DIAGNOSTIC PROCEDURE . > Go to step 2. 
2 CHECK POWER SUPPLY FOR SECURITY INDICATOR LIGHT. 
  1. Disconnect the connector from combination meter.
  2. Measure the voltage between the combination meter harness connector terminal and chassis ground.

    Connector & terminal 

    (i10) No. 1, 2 (+) - Chassis ground (-): 

 Is the voltage more than 10 V? Go to step 3.  Check the harness for open or short circuits between combination meter and fuse.
3 CHECK SECURITY INDICATOR LIGHT CIRCUIT. 
Measure the resistance between the combination meter harness connector terminal and the security control unit harness connector terminal.
Connector & terminal 
(i10) No. 17 - (i84) No. 33: 		 Is the resistance less than 10 Ω? Replace the combination meter. < Ref. to COMBINATION METER . > Check the harness for open or short circuits between the combination meter and body integrated unit.
scientia non olet · About LEMON Manuals