LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Security And Locks) >> Security System >> Inspection >> Check Security System Condition Memory
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Security System Condition Memory

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from ignition switch.
  2. Close all the doors, trunk lid and rear gate.
  3. Open the front hood.
  4. Press the LOCK button of transmitter, and then wait until the security indicator light flashes twice for 0.5 sec at intervals of 2 seconds.
  5. Disconnect the ground cable from battery.
  6. Connect the ground cable to battery.
  7. Check that the security indicator light blinks twice within 0.5 seconds at 2 seconds intervals. When it does not blink, replace the body integrated unit.
scientia non olet · About LEMON Manuals