Registration Of Keyless Transmitter With SUBARU Select Monitor

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

A maximum of four keyless transmitter can be registered for each individual vehicle.
When replacing or adding the keyless transmitter, new registration of transmitter is necessary.

Connect the Subaru Select Monitor to the vehicle.
Turn the ignition switch to ON.
From the «Main menu» on the Subaru Select Monitor, select the {2. Check individual system} → {7. Integrated unit mode} → {8. Transmitter ID registration}, and press the [YES] key.
Input the 8-digit ID number attached to the plastic bag of the transmitter, then press the [YES] key.
NOTE: Press the x key on the Subaru Select Monitor to increase the number, and the [x] key to decrease. Press the [<] key to move to the digit in the left, and [>] to the right.
The ID number you have entered will be shown. Make sure that the ID number shown is the same as that of plastic bag.
Press the [YES] key if the ID number is correct. Press the [NO] key if incorrect, to return to the step 3) and try again.
«ID registration in process» is displayed and registration starts.
«ID registration done...» will be displayed when the registration process is done.
To exit, select «END:NO», and press the [NO] key to return to {8. Keyless transmitter ID registration}. If there are additional keyless transmitters to be registered, select «Next registration:YES», and press the [YES] key to return to the step 3).
NOTE:
- If the registration fails, «ID registration failed. Try again.» will be shown. Press the [YES] key to return to the {8. Transmitter ID registration}. And retry from the step 2).
- «END: NO» is shown on the Subaru Select Monitor when fourth keyless transmitter has been registered. Press the [NO] key to return to {8. Keyless transmitter ID registration}.