LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 190 (Airbag System) >> Driver's Airbag Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driver's Airbag Module: Removal

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to "CAUTION" of "General Description" before handling the airbag module. <Ref. to CAUTION , General Description. >
  1. Position the front wheels straight ahead. (After moving a vehicle 5 m (16 ft) or more with front wheels positioned straight ahead, make sure that the vehicle moves straight ahead.)
  2. Turn the ignition switch to OFF.
  3. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  4. Using TORX® bit T30 (1), remove the two TORX® bolts on the side of steering wheel.
    Fig 1: Removing Two Torx® Bolts On Side Of Steering Wheel
    G04995690Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the horn harness.
  6. Disconnect the airbag connector on the back of airbag module, and then remove the airbag module. <Ref. to PROCEDURE , Airbag Connector. >
    Fig 2: Disconnecting Airbag Connector
    G05003918Courtesy of SUBARU OF AMERICA, INC.
  7. Refer to "CAUTION" for handling of a removed airbag module. <Ref. to CAUTION , General Description. >
scientia non olet · About LEMON Manuals