Select Cable: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the select cable to plate assembly.
Tightening torque: 18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 1: Identifying Select Cable
Install the select cable to range select lever.
Install the plate assembly to transmission.
Tightening torque: T:24.5 N.m (2.5 kgf-m, 18.1 ft-lb)
- 4AT
  
  Fig 2: Identifying Plate Assembly
- 5AT
  
  Fig 3: Identifying Plate Assembly
Install the washer and snap pin to range select lever.
- 4AT
  
  Fig 4: Identifying Washer And Snap Pin
- 5AT
  
  Fig 5: Identifying Washer And Snap Pin
Install new clamp paying attention to the installing direction.

Fig 6: Identifying Clamp
Insert the tip of inner cable into connector hole of select lever, and fix the cable to bracket.

Fig 7: Inserting Tip Of Inner Cable Into Connector Hole Of Select Lever
Shift the select lever to the "N" range, and then adjust the select cable position. < Ref. to ADJUSTMENT , Select Cable. >
Install the heat shield cover.

Fig 8: Identifying Heat Shield Cover
Install the front, center and rear exhaust pipes, and the muffler. (SOHC and DOHC non-turbo model)
- SOHC model
  < Ref. to INSTALLATION , Front Exhaust Pipe. > < Ref. to INSTALLATION , Center Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
- DOHC 3.0 L model
  < Ref. to INSTALLATION , Front Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >
Install the center, rear exhaust pipes and the muffler. (DOHC turbo model)
< Ref. to INSTALLATION , Center Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >