Airbag Control Module: Removal
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed or if the fault occurs by water, replace the airbag control module with a new part.
- Do not drop the airbag control module.
- After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
- Turn the ignition switch to OFF.
- Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
- Remove the console front panel and console side garnish. < Ref. to REMOVAL , Center Console. >
- Remove screws and pull out the audio unit assembly, and disconnect the connector for removal.
- Disconnect the connector from airbag control module.
- Remove the bolts and remove airbag control module.