LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Airbag System) >> Airbag Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Airbag Control Module: Removal

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Do not disassemble the airbag control module.
  • If the airbag control module is deformed or if the fault occurs by water, replace the airbag control module with a new part.
  • Do not drop the airbag control module.
  • After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
  3. Remove the center console. <Ref. to REMOVAL , Center Console .>
  4. Remove screws and pull out the audio unit assembly, and disconnect the connector for removal.
    Fig 1: Locating Audio Unit Assembly Screws
    G05022980Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the connector from airbag control module.
  6. Remove the bolts and remove airbag control module.
    Fig 2: Locating Airbag Control Module Bolts
    G05020505Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals