LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2008 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Occupant Detection System (Diagnostics)) >> Subaru Select Monitor >> Operation >> Clear Memory Mode
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Clear Memory Mode

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Clear the DTC stored in the airbag control module after repairing the airbag system and occupant detection system. (After the breakdown is recovered, the breakdown code for completed recoveries are read out when the next breakdown occurs if the memory clear work is not performed.)

  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu» display screen, select the {Airbag System}.
  3. On the {Airbag System} menu screen, select the {Clear Memory}.
  4. When the «Clear Memory?» is shown on the screen, select the [OK].
  5. When Done is displayed, turn the ignition switch to OFF and close the Subaru Select Monitor.
    NOTE: For details concerning operation procedures, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
scientia non olet · About LEMON Manuals