Side Protector: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- Apply primer to the protector surface where the double-sided tape is to be adhered, and then adhere the double-sided tape as shown in the figure.
Primer: 3M K-500 or equivalent
Double-sided tape: 3M 5531-5 or equivalent
- Heat the adhering part using a heat light. Body side: 40 - 60°C (104 - 140°F) Protector side: 20 - 30°C (68 - 86°F)
- Peel off the backing sheet of double-sided tape, align the clip position, and then adhere the tape to the body while taking care to avoid air entering.CAUTION: To keep the adhesion, do not wash the vehicle within 24 hours from installation.