Knock Sensor: Installation

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block.
NOTE: Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Tightening torque:

24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Identifying Knock Sensor Installation Position
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake chamber.
<Ref. to INSTALLATION , Air Intake Chamber.>
Connect the battery ground cable to battery.

Fig 3: Disconnecting Ground Cable From Battery

Courtesy of SUBARU OF AMERICA, INC.