Knock Sensor: Installation

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to the cylinder block.
NOTE: The portion of the knock sensor cord that is pulled out must be positioned at a 60° angle relative to the engine rear.

Tightening torque:

24 N.m (2.4 kgf-m, 17.7 ft-lb)

Fig 1: Identifying Front Side Of Knock Sensor
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the intercooler.
<Ref. to INSTALLATION , Intercooler.>
Connect the ground cable to the battery.

Fig 3: Identifying Battery Ground Cable
Courtesy of SUBARU OF AMERICA, INC.