Airbag Control Module: Removal

WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not disassemble the airbag control module.
If the airbag control module is deformed or if the damage from water is suspected, replace the airbag control module with a new part.
Do not drop the airbag control module.
After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.

Turn the ignition switch to OFF.
Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
Remove the console box. <Ref. to REMOVAL , Console Box . >
Center panel <Ref. to CENTER PANEL , REMOVAL, Center Console . >
Console front panel <Ref. to CONSOLE FRONT PANEL , REMOVAL, Center Console . >
Remove the audio.
Remove the heater duct.

Fig 1: Locating Heater Duct Bolts
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from airbag control module.
Remove the three bolts and remove airbag control module.

Fig 2: Locating Bolts And Airbag Control Module

Courtesy of SUBARU OF AMERICA, INC.