Front Sub Sensor: Installation
WARNING: This page is about a different car, the 2008 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal.
CAUTION:
- Do not reuse the bolt and nut.
Always use new bolts and nuts for them.
- When installing the sensor, securely insert the arrest pin on the back side of sensor into the body side hole.
- After attaching the headlight assembly, always perform headlight beam level adjustment.
Tightening torque: 13 N.m (1.32 kgf-m, 9.6 ft-lb)