Transmission Control Device: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the detention spring to the transmission case.
Tightening torque:

6 N.m (0.6 kgf-m, 4.3 ft-lb)

Fig 1: Identifying Detent Spring
Courtesy of SUBARU OF AMERICA, INC.
Insert the select lever, and then tighten the bolt.
Tightening torque:

6 N.m (0.6 kgf-m, 4.3 ft-lb)

Fig 2: Identifying Range Select Lever And Bolt
Courtesy of SUBARU OF AMERICA, INC.
Insert the manual plate and parking rod.

Fig 3: Identifying Manual Plate And Parking Rod
Courtesy of SUBARU OF AMERICA, INC.
Insert a new straight pin to manual plate.

Fig 4: Identifying Manual Plate Spring Pin
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan and the control valve assembly. < Ref. to INSTALLATION , Control Valve Body. >
Turn over the transmission case to its original position.
Install the pitching stopper bracket.
Tightening torque:

41 N.m (4.2 kgf-m, 30.4 ft-lb)
Install and adjust the inhibitor switch. < Ref. to INHIBITOR SWITCH . >
Insert the inhibitor switch and transmission connector to the stay.

Fig 5: Identifying Inhibitor Switch And Transmission Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air breather hose. < Ref. to INSTALLATION , Air Breather Hose. >
Insert the input shaft while rotating it lightly by hand, and then check the amount of protrusion.
Normal protrusion A:

50 - 55 mm (1.97 - 2.17 in)

Fig 6: Identifying Input Shaft
Courtesy of SUBARU OF AMERICA, INC.
Install the torque converter assembly. < Ref. to INSTALLATION , Torque Converter Assembly. >
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >