Control Valve Body: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Check the control valve body for dust and other foreign matter.
Install the control valve body to transmission by equally tightening the bolts.
Tightening torque:

8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 1: Identifying Control Valve Body To Transmission With Bolts
Connect the control valve connector.

Fig 2: Identifying Control Valve Connector
Attach the magnet at the specified position of the oil pan.

Fig 3: Identifying Magnet
Apply liquid gasket to the oil pan.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020)

Fig 4: Identifying Oil Pan Gasket Area
Install the oil pan by equally tightening the bolts.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Pour ATF through the oil charge pipe.
Specified and recommended fluid:

< Ref. to SPECIFICATION , General Description. >

Capacity:

Fill with the same amount of ATF as drained.
Check the ATF level.
< Ref. to AUTOMATIC TRANSMISSION FLUID . >
Perform Clear Memory 2 operation. < Ref. to CLEAR MEMORY MODE , OPERATION, Subaru Select Monitor. >
Perform the inspection with driving the vehicle at the end of repair work, and make sure there is no faulty as below;
- Excessive shift shock
- Oil leakage from the transmission body, etc.
- Occurrence of noise caused by interference etc.
NOTE: If excessive shift shock is felt, execute advance operation of learning control. < Ref. to PROCEDURE , Learning Control. >