Front Vehicle Speed Sensor: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the front vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Fig 1: Identifying Front Vehicle Speed Sensor Securing Bolt
Connect the front vehicle speed sensor connector.
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020)

Fig 2: Identifying Oil Pan Mating Surface
Install the oil pan by equally tightening the bolts.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Install the center differential carrier. < Ref. to INSTALLATION , Center Differential Carrier. >
Install the extension case.
Tightening torque:

25 N.m (2.5 kgf-m, 18 ft-lb)

Fig 3: Identifying Extension Case
Install the rear vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Fig 4: Identifying Rear Vehicle Speed Sensor
Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >
Pour ATF from the oil charge pipe. < Ref. to REPLACEMENT , Automatic Transmission Fluid. >
Check the level and leaks of ATF. < Ref. to INSPECTION , Automatic Transmission Fluid. >