Torque Converter Assembly: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback and 2006 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
- When the oil pump shaft is removed, install the shaft to torque converter.NOTE: Make sure the clip is firmly inserted.
- Install the oil pump shaft to torque converter, and then make sure that the clip is secured on groove.
- Apply ATF to the revolving and sliding surface of the oil pump shaft.
- Holding the torque converter assembly by hand, lightly rotate it to engage with the oil pump rotor.
- Check the protruding dimension of the torque converter assembly.
Dimension A: 8 mm (0.31 in) or less
- Install the transmission assembly to the vehicle. < Ref. to INSTALLATION , Automatic Transmission Assembly. >