Knock Sensor: Installation

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the knock sensor to cylinder block.
NOTE: Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.

Tightening torque: 24 N.m (2.4 kgf-m, 17.4 ft-lb)

Fig 1: Identifying Knock Sensor Installation Position
Courtesy of SUBARU OF AMERICA, INC.
Connect the knock sensor connector.

Fig 2: Identifying Knock Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake chamber.
<Ref. to INSTALLATION , Air Intake Chambers .>
Connect the battery ground cable to battery.

Fig 3: Identifying Battery Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.