How To Use The SUBARU Select Monitor

Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description.>

Fig 1: Identifying Subaru Select Monitor
Courtesy of SUBARU OF AMERICA, INC.
Prepare the personal computer which has been installed the Subaru Select Monitor.
Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
Connect the diagnosis cable to the SDI.
Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).

Fig 2: Locating Lower Portion Of Instrument Panel Data Link Connector (On Driver Side)
Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Do not connect the scan tools except for Subaru Select Monitor or general scan tool.
Start up the personal computer.
Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
Call up DTC and data, then record them.
NOTE: For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".