Clear Memory Mode: Operation
- Move the select lever to "P" range.
- Using the Subaru Select Monitor, select {Each System Check} in the «Main Menu».
- On the «Each System Check Menu» screen, select {Transmission Control System}.
- After transmission type information is displayed, select [OK].
- On the «Transmission Diagnosis», select {Clear Memory}.
- When "Done. Turn ignition switch OFF" is displayed, select [OK].
- Turn the ignition switch to OFF. When turning the ignition switch to ON again, wait for 10 seconds or more.
- Turn the Subaru Select Monitor OFF.
NOTE:
- If {Clear Memories 2} is executed, DTCs and learned control memory are cleared.
- If {Clear Memories 2} is executed, perform learning. Refer to LEARNING CONTROL .