Steering Wheel: Installation

WARNING: Always refer to "CAUTION " before performing service on the airbag modules.

Align the center position of the roll connector. Refer to ADJUSTMENT , Roll Connector.
Install in the reverse order of removal.
NOTE: Align the alignment marks on the steering wheel and steering shaft.

Tightening torque:

39 N.m (4.0 kgf-m, 28.8 ft-lb)

Column cover-to-steering wheel clearance:

2 - 4 mm (0.08 - 0.16 in)

CAUTION: Insert the roll connector guide pin into the guide hole on the lower end of the steering wheel surface. Avoid damaging the pin.